About electrical mesh in simulating perovskite solar cells
Posted: Fri Oct 25, 2024 5:05 am
Dear all,
I am trying to perform a 2D simulation of perovskite solar cells.
However, when increasing the electrical mesh in the x dimension, the simulation stops (see the attached image).
Could you please advise on ways to avoid this error and allow the simulation to run smoothly?
Best regards.
Takashi
I am trying to perform a 2D simulation of perovskite solar cells.
However, when increasing the electrical mesh in the x dimension, the simulation stops (see the attached image).
Could you please advise on ways to avoid this error and allow the simulation to run smoothly?
Best regards.
Takashi