Dear all,
I am reaching out with a question regarding the modulation light settings in the Oghmanano IMPS simulation.
Specifically, I would like to set the modulated light to a 488 nm blue laser with a DC intensity of 10 mW/cm² and an AC intensity of 1 mW/cm². Additionally, I need to apply steady illumination with AM1.5G at 100 mW/cm².
Could you please confirm if it is possible to conduct a simulation with these settings? If so, I would be grateful if you could provide instructions on how to configure this setup.
I would appreciate any guidance you could provide and if possible, a prompt response would be very helpful.
Best regards,
Takashi