Dear all,
I am trying to perform a 2D simulation of perovskite solar cells.
However, when increasing the electrical mesh in the x dimension, the simulation stops (see the attached image).
Could you please advise on ways to avoid this error and allow the simulation to run smoothly?
Best regards.
Takashi
About electrical mesh in simulating perovskite solar cells
About electrical mesh in simulating perovskite solar cells
- Attachments
-
- error.png (145.45 KiB) Viewed 213 times
-
- electrical mesh.png (247.24 KiB) Viewed 213 times